//pagead2.googlesyndication.com/pagead/js/adsbygoogle.js

Mechatronics Technologies Corporation

Mechatronics Technologies Corporation is an institution accredited by TESDA that offers Technical and Vocational Education and Training Programs (TVET) under the Technical Education and Skills Development Authority (TESDA) and the Commission on Higher Education (CHED).

Mechatronics Technologies Corporation

Address: 2nd Floor UP-ISSI Bldg., Jacinto St., Diliman, Quezon City, Philippines
Telephone Number: 925-5167; (632) 928-3307; (632) 928-6297; 928-330

TESDA Approved Programs

Here is the list of available TESDA registered programs and short courses offered in “Mechatronics Technologies Corporation” in Quezon City.

List of Tesda Courses Offered / Registered Programs

Course Authorized Duration
30 Hr. Basic Industrial Automation Technologies 30 hours
40 Hr. Basic Process Automation Instrumentation 40 hours
Electrical Installation & Maintenance NC II 936 hours
Electrical Installation & Maintenance NC III 396 hours
Instrumentation & Control Servicing NC II 238 hours
Instrumentation & Control Servicing NC II (Mobile Training) 238 hours
Instrumentation & Control Servicing NC III 176 hours
Instrumentation & Control Servicing NC III (Mobile Training) 176 hours
Instrumentation & Control Servicing NC IV 170 hours
Instrumentation & Control Servicing NC IV (Mobile Training) 170 hours
Mechatronics SERVICING NC II 174 hours
Mechatronics Servicing NC II (Mobile Training) 182 hours
Mechatronics Servicing NC III (Mobile Training) 192 hours
Mechatronics SERVICING NC IV 186 hours
Mechatronics Servicing NC IV (Mobile Training) 186 hours
Mechatronics SERVICNG NC III 192 hours

Basic Requirements for TESDA Courses:

  • At least 18 years of age
  • At least High School Graduate
  • Copy of NSO Birth Certificate
  • With good moral character
  • Undergone a pre-training assessment
  • Can communicate both orally and in written form

Training Fees and Schedule

The cost of training and tuition fees may vary depending upon the specific course of interest and the school offering the training. Training centers also may have slightly different syllabus to teach to students in a class.

For inquiries, tuition fees, enrollment procedures, class schedule and other concern, it would be better that you visit their school/training center and inquire for other documents they may need.

Location and Contact Information

For further information, please contact the school directly at telephone number 925-5167; (632) 928-3307; (632) 928-6297; 928-330. You can also visit Mechatronics Technologies Corporation. The assessment center is located at 2nd Floor UP-ISSI Bldg., Jacinto St., Diliman, Quezon City, Philippines.


Leave a Reply

Your email address will not be published. Required fields are marked *

Tesda Courses © 2015 Privacy | Disclaimer | Terms of Use