Technological Institute of the Philippines – Cubao

Technological Institute of the Philippines – Cubao is an institution accredited by TESDA that offers Technical and Vocational Education and Training Programs (TVET) under the Technical Education and Skills Development Authority (TESDA) and the Commission on Higher Education (CHED).

Technological Institute of the Philippines – Cubao

Address: 20th Avenue., Cubao, Quezon City, Philippines
Telephone Number: 912-1461
Website: http://www.tip.edu.ph

TESDA Approved Programs

Here is the list of available TESDA registered programs and short courses offered in “Technological Institute of the Philippines – Cubao” in Quezon City.

List of Tesda Courses Offered / Registered Programs

Course Authorized Duration
Technical Drafting NC II 148 hours

Basic Requirements for TESDA Courses:

  • At least 18 years of age
  • At least High School Graduate
  • Copy of NSO Birth Certificate
  • With good moral character
  • Undergone a pre-training assessment
  • Can communicate both orally and in written form

Training Fees and Schedule

The cost of training and tuition fees may vary depending upon the specific course of interest and the school offering the training. Training centers also may have slightly different syllabus to teach to students in a class.

For inquiries, tuition fees, enrollment procedures, class schedule and other concern, it would be better that you visit their school/training center and inquire for other documents they may need.

Location and Contact Information

For further information, please contact the school directly at telephone number 912-1461. You can also visit Technological Institute of the Philippines – Cubao. The assessment center is located at 20th Avenue., Cubao, Quezon City, Philippines.


1 Comment

Add a Comment
  1. Hi, I am presently working in Riyadh Saudi Arabia since 1990. I have taken my bachelor in architecture in FEU way back 1983-1989 but have not finished the course. Would my credit units taken in FEU could be considered to waive the number of hours/ units if I would take a Technical Drafting course in your institution. Actually I am just doing this to get a certificate attested by TESDA coz it is a mandatory requirement in Saudi Council of Engineers in able to renew my residence permit for this year. Other query I would to know is whether you have an on line course or it is necessary to be there personally and how many hours/ day maximum I can get coz I can only get a short vacation break in my office to take that course. I am currently employed with Al Yamamah University as the Asst. of the VP. Hoping to get an update from you ASAP. Thank you.

Leave a Reply

Your email address will not be published. Required fields are marked *

Tesda Courses © 2015 Privacy | Disclaimer | Terms of Use